How to Install a Garage Door Bottom Seal

Installing a garage door bottom seal is an important task that can help keep your garage clean and free from drafts. Here is a step-by-step guide to help you install a garage door bottom seal:

Step 1: Measure the width of your garage door opening. This will help you determine how much seal you need to purchase.

Step 2: Clean the bottom of your garage door. Use a broom or vacuum to remove any debris or dirt that may be on the bottom of your garage door.

Step 3: Cut the garage door bottom seal to the appropriate length. Use a utility knife or scissors to cut the seal to the length of your garage door opening.

Step 4: Attach the garage door bottom seal to the bottom of the garage door. Start at one end and work your way to the other end, using a rubber mallet to gently tap the seal into place.

Step 5: Secure the garage door bottom seal in place. Use screws or nails to secure the seal to the bottom of the garage door. Make sure to space them out evenly along the length of the seal.

Step 6: Test the garage door to ensure that the seal is properly installed. Open and close the garage door to check for any gaps or areas where the seal may not be properly attached.

By following these steps, you can successfully install a garage door bottom seal and help keep your garage clean and free from drafts.