| Tools and Supplies to Repair a Garage Door Cable | ||||
|---|---|---|---|---|
| 1 | Adjustable wrench | |||
| 2 | Needle-nose pliers | |||
| 3 | Cable cutters | |||
| 4 | Vise grips | |||
| 5 | Safety glasses | |||
| 6 | Cordless drill | |||
| 7 | Screwdriver set | |||
| 8 | Socket set | |||
| 9 | Hammer | |||
| 10 | Pry bar | |||
Garage doors are an essential part of our daily life, and it is crucial to maintain them regularly to ensure their proper functioning. One of the common problems that garage doors face is a broken or damaged cable. The cable is responsible for lifting and lowering the door, and if it is broken, the door may not open or close correctly. In this article, we will guide you on how to repair a garage door cable step by step.
Step 1: Disconnect the Power
Before you start repairing the garage door cable, it is crucial to disconnect the power source. You can do this by unplugging the garage door opener or turning off the power supply from the circuit breaker.
Step 2: Open the Garage Door
You need to open the garage door fully to access the cable. You can do this manually by pulling the emergency release cord, which is usually located near the opener. Once you have pulled the cord, you can lift the door manually.
Step 3: Remove the Damaged Cable
Locate the damaged cable and remove it from the drum and the bottom bracket. You can do this by loosening the cable clip or bolt that holds the cable in place. Once you have removed the cable, inspect it thoroughly to determine the extent of the damage.
Step 4: Install the New Cable
Get the new cable and attach it to the drum and the bottom bracket, ensuring that it is tight and secure. You can do this by tightening the cable clip or bolt that holds the cable in place. Make sure that the cable is properly aligned and not twisted.
Step 5: Wind the Cable
Now that you have installed the new cable, you need to wind it around the drum. You can do this by turning the drum with a winding bar until the cable is tight. Make sure that the cable is evenly wound and not overlapping.
Step 6: Test the Garage Door
After you have wound the cable around the drum, you can test the garage door to ensure that it is functioning correctly. You can do this by closing and opening the door using the garage door opener or manually.
Step 7: Reconnect the Power
Once you have tested the garage door and ensured that it is functioning correctly, you can reconnect the power source. You can do this by plugging in the garage door opener or turning on the power supply from the circuit breaker.
In conclusion, repairing a garage door cable is not a complicated task, but it requires caution and attention to detail. By following these steps, you can repair the cable and ensure that your garage door is functioning correctly. However, if you are not comfortable with repairing the cable yourself, it is advisable to seek the help of a professional.