is supported by readers and may earn an affiliate commission.

Rather have a pro do it for you?

Tools and Supplies to Replace a Garage Door Panel
1 Cordless Drill
2 Screwdriver Set
3 Pliers
4 Hammer
5 Pry Bar
6 Tape Measure
7 Safety Glasses
8 Work Gloves
9 Level
10 Paint Scraper
11 Sawhorses
12 Circular Saw
13 Jigsaw
14 Safety Goggles
15 Dust Mask

How to Replace a Garage Door Panel

DIY Guide: Easy Steps to Replace Your Garage Door Panel

Replacing a garage door panel may seem like a daunting task, but it can be done with the right tools and some careful planning. Here's a step-by-step guide on how to replace a garage door panel:

Step 1: Measure the Door Panel
Before you start, you need to measure the garage door panel that needs to be replaced. Measure the width and height of the panel, and make sure to measure from the inside of the door frame.

Step 2: Order the Replacement Panel
Once you have the measurements, you can order the replacement panel from your local garage door supplier. Make sure to order the correct size and style of panel to match your existing door.

Step 3: Remove the Damaged Panel
To remove the damaged panel, you will need to first remove the hinges that attach the panel to the door frame. Use a socket wrench to remove the bolts and lift the panel out of the frame.

Step 4: Install the New Panel
Place the new panel into the door frame and attach it to the hinges using the bolts and socket wrench. Make sure the panel is securely attached to the hinges and that it is level with the rest of the door.

Step 5: Reattach the Hardware
Once the new panel is in place, you will need to reattach the hardware, including the rollers, tracks, and springs. Make sure everything is properly aligned and tightened.

Step 6: Test the Door
After the new panel is installed and the hardware is reattached, test the door to make sure it opens and closes smoothly. If there are any issues, adjust the hardware as needed.

Replacing a garage door panel can be a challenging task, but with the right tools and some careful planning, it can be done. By following these steps, you can replace a damaged panel and have your garage door looking and functioning like new.