How to Replace a Garage Door Cable

Replacing a garage door cable can be a daunting task, but with the right tools and knowledge, it can be done quickly and easily. Follow these step-by-step instructions to replace a garage door cable:

Step 1: Disconnect the Garage Door Opener

Before you begin replacing the cable, make sure to disconnect the garage door opener. This will ensure that the door does not accidentally open or close while you are working on it.

Step 2: Release the Tension on the Cable

Next, release the tension on the cable by using a pair of locking pliers to hold the cable in place. Then, loosen the cable from the drum by using a wrench to turn the bolt counterclockwise.

Step 3: Remove the Old Cable

Once the tension has been released, you can remove the old cable from the drum by pulling it out. Be sure to remove the cable from the other end as well.

Step 4: Install the New Cable

To install the new cable, feed one end through the drum and secure it in place with a bolt. Then, feed the other end of the cable through the pulley and attach it to the garage door.

Step 5: Tighten the Cable

Once the new cable is in place, use a wrench to tighten the bolt on the drum. This will create tension on the cable and ensure that it is properly secured.

Step 6: Test the Door

Finally, test the garage door to make sure that it is functioning properly. If everything is working as it should, you can reconnect the garage door opener and resume normal use.

Replacing a garage door cable may seem like a daunting task, but with these step-by-step instructions, you can easily replace a damaged or worn cable and ensure that your garage door is functioning properly.